Print Page | Close Window

has anyone tried this flies solution for '12 ZX14?

Printed From: Brock's Performance
Category: YOU have questions....WE have answers!!
Forum Name: The ACTION ! - Brock's Question and Answer Forum
Forum Description: Answer to common questions.....AND some questions you didn't even know to ask!
Printed Date: June/02/2020 at 3:19am
Software Version: Web Wiz Forums 12.01 -

Topic: has anyone tried this flies solution for '12 ZX14?
Posted By: Jkatk3v
Subject: has anyone tried this flies solution for '12 ZX14?
Date Posted: July/22/2012 at 5:34pm
I have stripped down my bike (2012 ZX14) and taken off the stock exhaust so I could install the AlienHead2 as soon as it gets delivered. As I was looking the bike over I noticed (what I think is) the controller for the secondaries.
Would it be possible to unhook or bypass the secondary flies controller like I have in the picture...outlined in red
and then on other side of the shaft, rotate and lock the flies in the open position.
this picture shows the other side of the shaft the flies are on. by rotating this end of the shaft you can open or close the flies manually and maybe lock them open
If this works it would be much simpler than taking the flies out and easier to return to "stock form"

Posted By: tommy2671
Date Posted: July/24/2012 at 5:45am
It would probably be possible that way, but the bikes computer is going to throw a fault code with them being just unplugged,You would have to jumper the wires or may have to put a resistor in line with the jump wire! IMHO it may be a bit easier just to take the screws out and remove the blades instead of messing with the electronics!

Posted By: Jkatk3v
Date Posted: July/25/2012 at 6:50pm
Looks like I can do this with the new ECU flash. Thanks again Brocks! -

Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.01 -
Copyright ©2001-2018 Web Wiz Ltd. -