|
SURGING - Event Date: January/01/1900 - January/01/1900 |
Post Reply 
|
| Author | |
STEVEN 
Senior Member 
Joined: February/02/2003 Status: Offline Points: 18 |
 Post Options
 Thanks(0)
 Quote Reply
 Calendar Event: SURGINGPosted: December/20/2003 at 7:13pm |
|
I just installed a 2002 engine in my 2000 busa. I changed the complete wire harnes and computer. The bike runs perfect except for a bad serging problem in any gear at 2500 to 3000 rpms . Any ideas to fix the problem ? Thank You Steven Lombardi
|
|
 |
|
|
fstbusa
Senior Member
Joined: September/22/2003 Location: United States Status: Offline Points: 97 |
Post Options
Thanks(0)
Quote Reply
Posted: December/20/2003 at 10:14pm |
|
what did you swap out the harness and ecu??
map might be different from before since its a complete different ecu, |
|
|
03 40th Ann. Ghetto Busa
|
|
|
|
|
STEVEN
Senior Member
Joined: February/02/2003 Status: Offline Points: 18 |
Post Options
Thanks(0)
Quote Reply
Posted: December/21/2003 at 7:12am |
|
Fstbusa I changed the complete wire harnes,trotle body,rotor.tps,and the coils. I kept the gen 2 exhaust and installed a pc3r with BDE 027B Gen 3 map. I gone the best with this set up at the track 9.42 at 146.80. Except for that surge at 2500 it is wonderfull.
|
|
|
|
|
fstbusa
Senior Member
Joined: September/22/2003 Location: United States Status: Offline Points: 97 |
Post Options
Thanks(0)
Quote Reply
Posted: December/22/2003 at 9:03pm |
|
I was just curious what you swapped out the harness?? was it bad?
|
|
|
03 40th Ann. Ghetto Busa
|
|
|
|
|
STEVEN
Senior Member
Joined: February/02/2003 Status: Offline Points: 18 |
Post Options
Thanks(0)
Quote Reply
Posted: December/22/2003 at 11:45pm |
|
There are a few wires that were not in the same slot so it was easier to change the complete harness. |
|
|
|
|
fstbusa
Senior Member
Joined: September/22/2003 Location: United States Status: Offline Points: 97 |
Post Options
Thanks(0)
Quote Reply
Posted: December/23/2003 at 8:18am |
|
I don't know much about the wiring on the busa but changing out the harness could have caused some problem. |
|
|
03 40th Ann. Ghetto Busa
|
|
|
|
|
STEVEN
Senior Member
Joined: February/02/2003 Status: Offline Points: 18 |
Post Options
Thanks(0)
Quote Reply
Posted: December/23/2003 at 11:19am |
|
Fstbusa It is just a matter of pluging it in . Any way i installed a Bde 028a Gen 3 map and it seamed to cure the problem. It is still to cold to ride far but it seams good for now.Thanks Steven Lombardi
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options